Aussieveedubbers · Help out a Dubber

tilta tech car tilting assembly

https://forums.aussieveedubbers.com/threads/101967/tilta-tech-car-tilting-assembly

roverv8bay ·

Gday all. I need the use of a rotissery to suit bay. Happy to pay for it. I have to roll on it's side to fit the chassis boxing to it for the midmount engine & transmissions between. Gympie & goldcoast. Be home Monday. If you can help please pm me
Ernie

roverv8bay ·

G'day all just bought a tilta tech tilting cradle that will tilt up to 1750kg vehicle it is powered by electric drill to lift it. after I have used it on ECLECTIC it will be available for hire between sunshine coast & gold coast
ernie

roverv8bay ·

G'day all. This the lifter I have obtained. once I have finished with it I will be hiring out to members of the associated clubs. at a yet to be determined reasonable cost.
ernie



68BUS ·

I thought kombis were closer to the early 2000kg's??

Decent looking system though? and I am sure there is a bit of safety margin in the sizing of the units too.

h ·

68BUS wrote:I thought kombis were closer to the early 2000kg's??

Decent looking system though? and I am sure there is a bit of safety margin in the sizing of the units too.
🙄

nah... bay kombis are about 1300kgs mate n splits a little less or there abouts

🤓🤓🤓😘

nils ·

Hey Ernie, i'll be looking for something like this in the next few months aswell for my bus. where did you get yours from?

roverv8bay ·

Gday Nils I just happened to mention to a friend that I was going to build something & he said I have anew 1 for sale needless to say I pick it up tomorrow the catch being its at the far end of a 40 foot container. I think theres something he wants out of it so I do the work he gets his stuff as well. but not worry I got a bargain. the kombi has no motor or transmission in it no trim so should handle that ok. t the worst I will drop doors off. If you only need short term happy to hire to members. I only need it because of bad back & arthritis so save laying on creeper to do the under floor welding etc
ernie

nils ·

I want to clean and paint the underside. while i have done it before by climber under there all suited up, its not something i plan to repeat.

I can imagine it would only take a couple of weekends. But you are nowhere near me