leaking carby

Hi
I've found a bit of a problem with my carb.It works great drives well, idles great etc. Except when I park the car facing up an incline. When i do this fuel runs out at each end of the butterfly shaft, if i turn the car round it's fine.
I figure it's the pressure of the fuel gravity feeding into the carb.
Is there an easy way to stop this happening?

The needle and seat are leaking. If not fixed you run the risk of filling your engine full of fuel and then it can cause a few issues.

Yarp, needle valve needs replacing 🙂

thanks guys, I put a new one in when i put the carby kit through it a few weeks back.Thats about when it started to happen,must be faulty.I'll put the old one back in.

also, check if your engine oil level has increased in the meanwhile, because if too much fuel has got into the crank case it will have wrecked the oil, and it should be replaced.

Not necessarily a faulty float valve, rusty dirty fuel can stop a perfectly good one from sealing as well.

matberry wrote:The needle and seat are leaking. If not fixed you run the risk of filling your engine full of fuel and then it can cause a few issues.

Done it, not cool.
fix it soon as you can