I am splitting a motor heads and everything is off , how do I get the barrels Of without damaging them?
I am assuming that this is the thing to do next before splitting the box?
Mitchell Thanks again gurus
Bizarre ·
A motor stand is handy here so as you can get a good swing in both directions.
With the motor sitting flat and a wooden/urethene/rubber mallet you tap perpedicularly (is that a word??) and slowly loosen the pot.
If you what too hard or at an angle you could/will brake a few fins on the barrels.
Take it slow and if it wont come - do another one and come back.
lugnuts ·
Is the flywheel off yet,jus checkin and if your gunna reuse your lifters yule hafta hold onto them before you split the case.Have fun anyway Michell 🙂