WTB - BNE - Type 3 rear sub-frame (bare).

MikeM · 17 Mar 2005, 11:31 am

Hi,

I'm chasing a Type 3 rear sub frame completely bare, no training arms etc. It can even have the pivot boxes cut off if someone who has done an IRS conversion has one lieing around.

have a use for the yoke part (the part that goes forward under the type 3) for a project so the rest of the assembly can be buggered.

If anybody can help let me know.

Thanks

best to send me a u2u

Mike
0403 00 3833
Everton Park, Brisbane.

[Edited on 29/3/2005 by MikeM]

SKEWtYpe3 · 17 Mar 2005, 11:33 am

ive got a bent one for ya !

MikeM · 17 Mar 2005, 11:37 am

A bent one would be fine but it needs to be in Brisbane, Shipping one from Vic would cost to much.

Andy · 17 Mar 2005, 11:38 am

Hmm... I was chasing a complete rusty type 3 for the similar thing (rear end).
Not sure what I can get the whole car for but if cheap enough I can wreck and you take rear end, share the cost of buying the car.

I know Mick has a few stripped type 3 body's, don't think he'd want much just for that bit if you cut it out.

Richard

MikeM · 23 Mar 2005, 5:20 pm

This picture shows the section of metal I am chasing. Basically just the Y on the front.

[Edited on 29/3/2005 by MikeM]

Andy · 29 Mar 2005, 11:56 am

Did you try Mick's?
What are you willing to pay for it? (re-above)

MikeM · 29 Mar 2005, 11:58 am

Andy wrote:Did you try Mick's?
What are you willing to pay for it? (re-above)

Very little. The part I am chasin is basically a useless part that everyone throws out after using a type 3 rear end for an IRS conversion on an early beetle.

amazer · 29 Mar 2005, 12:14 pm

If you only want that piece, cant you use a swinger as well? Im not in BNE and dont have one, but maybe some people arent looking in here cos you have IRS in the subject.

MikeM · 29 Mar 2005, 12:17 pm

amazer wrote:If you only want that piece, cant you use a swinger as well? Im not in BNE and dont have one, but maybe some people arent looking in here cos you have IRS in the subject.

Thanks for the head up. I have no idea what a early type 3 rear end looks like. If it has the same yoke part then one of them will do.

Andy · 29 Mar 2005, 1:46 pm

If that's the case, wouldn't Custom have some?
I'll chase up the type 3 I know of and see what he want's for it.

MikeM · 4 Apr 2005, 11:16 am

bump

amazer · 4 Apr 2005, 8:34 pm

This is a swing axle version. Probably slightly different near the torsion bar housing..

vw54 · 5 Apr 2005, 7:42 am

Got one here in Sydney but shipping would kill it

MikeM · 6 Apr 2005, 10:39 am

bump

MikeM · 13 Apr 2005, 2:49 pm

bump

DallanMulley · 13 Apr 2005, 3:44 pm

Try Mark "Midlife crisis" or his phone no is 38052038 he has several late fastbacks to wreck.