Temp Sender location????

Were does everyone put there temp senders?

Mine used to be on the oil pressure attachment (by previous owner) but doesn't get the oil flow in this area to measure effectively.

It's a VDO 150 degree.

Marty

i use a vdo dipstick sender it works fine

tapped into the case or into the sump plate.

marty_08 wrote:Mine used to be on the oil pressure attachment (by previous owner) but doesn't get the oil flow in this area to measure effectively.

that is where mine was and i thought it read fine. High - but consistent.

Mine barely made the needle move when it was on the pressure attachment. It definately was working b/c when i broke it and pluged it in it was reading 150 degrees on the gauge (concerning initially!!!) even when only ignition on and engine not running.

If people could post pictures that would be great to give me a better idea about the exact position.

This dip stick temp sender sounds interesting Barls and pics mate???

Marty

The dipstick sender has been the Best Way to measure the oil temperature - as the dipstick is in the oil....

It looks like a dipstick with an attachment on the end with a wire coming off it..... VDO Make them....

Mine is in the sump plate.... instead of a sump plug....
neat.... I hadn't seen one before....
Its now in a CB Performance Maxi filter sump....

Lee

http://community.webshots.com/user/vw68autobug

Ok, the dipstick looks good!!!

I did have a look on the VDO online catalogue last night after u mentioned it and i saw it there too. Great idea.... just what i'm looking for!!!!!

Thanks guys much appreciated.

Marty

PS 68AutoBug the website looks good!!!!!

Make sure the dipstick sender is set longer* than your normal dipstick, because the sump oil level drops once the engine is running and will therefore give an inaccurate reading.

They are adjustable, (but not too long)

I think Hellbug used to sell a modified pressure relief screw (the big flathead screw/bolt under the engine some engines have 1, dual relief have 2)- centre was drilled and tapped to the appropriate thread for a screw in sender. I used this successsfully in my type 3 when it was on the road...once upon a time. :-( It would not be hard to make your own.
The Kombi has a VDO dipstick sender which seems to always let me know when things are getting a bit too warm back there on long trips.
Toby

marty_08 wrote:PS 68AutoBug the website looks good!!!!! Marty

Thanks Marty,
I always forget to take pics when I have pulled things like the front end out and apart.... as when I get greasy hands
naturally I don't think of touching the camera 🙂🙂

Car is nearly on the road.... I just have to finish the interior
and get the rear window tinted by someone...
there are a few small electrical things also to do... but everything works... even if You have to open the bonnet to turn the headlamps on...🙂🙂 I just want to drive it....!!
cheers

Lee