1835cc
Counterweighted crank
92mm Mahle pistons
Engle 120 cam
Bug pack wide face lifters
double thrust cam bearings
Bugpack solid rocker shafts
New Ported Big Valve heads
CB Performance high volume oil pump with full flow
Remote oil Filter
Remote 8 pass Empi Oil Cooler
Dog house cooler
Lightened 8 dowelled flywheel
50 amp Alternator
Empi extractors
009 distributor
new clutch
Dual 40mm Kadron Carby's and linkage
Custom exhaust with turbo muffler tucked up drivers side guard
Engine has just been run in, less than 1000kms
cost in excess of $6000
asking $3500 complete just bolt in drive
0148371724
located north central Vic
71superbug ·
any idea of the output of this motor?
and what is the compression?
Anthony
brenton74 ·
compression is 9.2:1 and the heads have all been cc'd,
as far as hp output i dont dare make a statement for fear of persecution. It was built for a relatively heavy L model that's lumbersome mass was only increased by the additional interior and exterior accessories it was adorned with, and it performed very well with useable rev range of 2500rpm up to 6000rpm. The full potential has not been tested as it was still being run in (it's only just had its 1000km oil change and service. The mechanic who serviced it said he got quite a shock when he picked it up to be serviced not knowing it wasn't stock.
bond ·
fantastic vocab brenton.. hehe :thumb
brenton74 ·
Yeah well God asked my parents did they want a good looking son or a smart one..............
brenton74 ·
bugger..............................
mountainbug ·
that's a bargin...
after spending around 4k on 1776
that's a good price, should go quick
[Edited on 31-3-2005 by mountainbug]
BenettonVW ·
Yes folks, this goes quite well, and as the owner says, it isn't even run it yet..
byronbus ·
pic? Good price...
brenton74 ·
bump
brenton74 ·
will get get camera and get pics soon, but warning you it just looks like an engine with dual carbs, no fancy chrome, the tinware was coated in Honda wrinkle black for heat dispersion properties, but i suppose the red GT coil looks shiny
brenton74 ·
bump, no pics yet
brenton74 ·
sorry been a bit slack, stuck on the other project, hopefully have photo's this weekend
VolksFolks ·
brenton74 wrote:will get get camera and get pics soon, but warning you it just looks like an engine with dual carbs, no fancy chrome, the tinware was coated in Honda wrinkle black for heat dispersion properties, but i suppose the red GT coil looks shiny