Porsche 550 Spyder Kit

I am finalising the importation of a container of Spyder kits from the manufacturer in Brasil. Space for one more car!!

See the attached link.

http://s24.photobucket.com/albums/c47/Judsons4eva/

RHD drive kits available, painted, leather seats, instruments, hood, wiring and hydraulics. You will need to add front hubs and brakes, transmission and engine.

This is the "Beck" Spyder which is now marketed under the manufacturer's name "Chamonix" name.

Swing axle for air cooled engine and IRS (de Dion) for water cooled VW engines available.

Can be built and registered under ICV regulations. Each State Licensing authority interprets these differently. I can provide assistance in licensing.

Price landed in Sydney $28,000.

Estimated value when complete $60,000 based on several cars on the market at the moment.

U2U or call Ken on 0413703003

Regards

Ken Johnsen

[ Edited on 28-6-2006 by Judsons4eva ]

Any interest? Boat leaving soon from Brazil!

They look quite good - but I just checked my wallet and I didn't have $28K in there. I musta spent it all on Saturday!

Free bump

Why aircooled for swing axle only, why not IRS?

The kit is as close as possible to the original 1955 car - hence swing axle. It can be converted to IRS but ex factory it is either swing axle or dedion. The dedion rear end car is set up with radiator etc for water cooled engines.

Ken

have always luved the spyders.

Even over the 356es, one day... one day...

did you get any orders from Perth Ken ?

No - all east coast.

Once I have mine on the road (officially) will start wider promotion.

Very close!!

Just as I cut all the diffs with the 9" you tell me this

I hope to pass you soon , with a subaru

No chance - get used to the rear end of my Spyder - "Porsche Power"

If it was a 356 Coupe replica I'd be keen.....

Yes can 356 speedster or Super 90 convertible - approx same price - go to www.chamonixcars.com.br or www.beckspeedsters.com for details of cars.
Not yet prepared one for rego in Aus. Need to worry about installing side intrusion bars in the doors and also finding an engine that will meet the ICV emission laws.

[ Edited on 4-7-2006 by Judsons4eva ]

Nah...only interested in Coupes not convertibles or speedsters....not so much into the show pony open air look (having said that my bug is out there, but has roof intact slightly lower)

Like this one made in Mexico. 356 Coupe

Those beck speedsters do look nice....