Greese for torsion bar front end.

Just wondering what greese you guys use when serviceing thre front torsion bar. Just fitting new front beam and need to service it. All info taken on board.........

Thanks Matt.

just a general purpose grease is fine, dont need any high temp or pressue stuff.

general purpose is good

If its a new beam jack the car n take the weight off the front end then grease it

also do this every few weeks while the beam is new as the grease moves around inside the beam

Thanks very much for that guys 🙂

I use the black stuff - apparently it;s better for sliding components

VWCOOL wrote:I use the black stuff - apparently it;s better for sliding components

I use Castrol LMM (the black stuff) in everything, wheel bearings, CVs, Front beams. It's great as it's water resistant

http://www.castrol.com/castrol/multipleproductsection.do?categoryId=8000019&contentId=7000402

Excellent........ I'll be off down the shops soon so thanks again guys for info................

There is ONLY one grease to use....

Castrol LMM black Lithium based Moly grease...

as Mick said....
its best for everything....

great for things that You don't want to wear out...

Clay based chassis grease is rubbish....

Any brand of Lithium based Moly Grease .... will do...
Castrol also have a Blue Lithium complex grease...

I've been using it for over 40 years....

Lee

http://community.webshots.com/user/vw68autobug