Looking for small front cut for my 70 lowlight panel

Hi guys,

I need this section for my 1970 lowlight panel. I started cutting the rust from the lower windscreen and i turns out it's had a hit right in the centre -- a heap of bog!

This is the section i need. I really only need about 2 inches down from the lower windscreen but it will be easier to join/ weld it at the air vent. Can anyone help?

See image here: http://rossandkim.com.au/window.jpg

That piece doesn't look too complicated, you could probably bend one up yourself out of flat sheet.

Yes but it curves both ways. I guess i can try but it would be easier if i had a cut as i know it will fit straight in.

I "might" have this section, as well as the wheel well you where chasing earlier?

They are attached to an early lowlight at my oldies place, so I might not be able to check for about a week & a half.

I'm at Taree NSW, so obviously if you get one closer it would be easier for you. Let me know if your interested.

Cheers
Brendan

Hi Brendan,

Thanks mate. Yes i'm interested. Can you let me know if these are available. I'm back working on the car in about 4 weeks so i'd like to have them by then.

Cheers,
Ross

Ross, check your PM box, I may be able to get these cuts for you this weekend.

Cheers
Brendan