Beam Adjusters

Has anyone had drama fitting these?



I've cut my linkpin beam in half and tried to fit the round leave block into the tube.
Sucker doesn't fit.
The block measures 45mm diameter. I have a mate with some 'avis style' adjusters from cip1 and the block is 44mm diameter.
WTF???

Crazy crazy....... CRAZY. Typical EMPI 😂

The whole idea of the Avis adjuster is that you don't have to cut the beam...... 😂😂

guru wrote:Has anyone had drama fitting these?



I've cut my linkpin beam in half and tried to fit the round leave block into the tube.
Sucker doesn't fit.
The block measures 45mm diameter. I have a mate with some 'avis style' adjusters from cip1 and the block is 44mm diameter.

Trouble with EMPI chinese stuff..

it all looks the same but near enough is NOT good enough..

reason I have never had them they were always very expensive in Australia...

they are the way to go..

LEE

PS: EMPI trade mark is owned by Wolfsburg automotive NOT the mob that has these made...

another QUALITY EMPI product

buy cheap CRY twice

LEE

PS: EMPI trade mark is owned by Wolfsburg automotive NOT the mob that has these made... [/quote]

I think you will find Wolfsburg only own the Australian rights to Empi, there is still a company in California who is using the name

Empi® COPYRIGHT 2011, EMPI INC. ANY REPRODUCTION OF, ALL OR PART, OF THIS CATALOG IS STRICTLY PROHIBITED WITHOUT THE WRITTEN CONSENT OF EMPI INC. SHOULD ANY OF OUR CUSTOMERS WISH TO REPRODUCE PART OR ALL OF THIS CATALOG, PLEASE SUBMIT A DETAILED REQUEST IN WRITING TO EMPI INC, 301 E. ORANGETHORPE AVE., ANAHEIM, CA 92801.
EMPI® is a registered trademark of EMPI INC.

Some light reading

http://www.thesamba.com/vw/forum/archive/index.php/o-t--t-189600--.html

http://beetle.cabriolets.online.fr/gallery/kseume/empi.html

matberry wrote:Crazy crazy....... CRAZY. Typical EMPI 😂

The whole idea of the Avis adjuster is that you don't have to cut the beam...... 😂😂

How do you get the lock out?

Am I the first to ever try fitting these??

I use the original, it, never leaves the beam.

Yes

Mr BUG in the USA has all the bits made in China etc..
Taiwan etc..

LEE

I looked at these Puma type adjusters but the 2 broad dimples in my LP beam meant it woulda been a bugger to try and remove the dimples so I just used sway aways.

Also the locating teeth on those cheap EMPI's are shite.

^^^ I agree, re quality and a pain to fit. I use Sway-a-way style due to easier adjustment, altho I always recommend using front end braces as the beam is weakened where the Avis style doesn't weaken the beam (if fitted corectly....... 😉 )

If the weld on the beam is done to the correct specs for the aplication it will not weaken the beam, a root run with the tig and cap run over that will do the trick.

front end beam I've just fitted [with height adjusters]
off a 1969 German beetle..



My beam had a RH front wheel in positive camber..
so I'm hoping this one is OK...

LEE