Spindle Assembly - Brisbane Ipswich area
Allbones - February 13th, 2013 at 12:54 PM
I require someone in the Brisbane/Ipswich area to assemble my drop spindles for me.
I dont feel that I have the experience required to do this, as well as the tools, and would feel much more comfortable if I was to have someone more
qualified then I do them.
Can you guys reccomend anyone that would be able to do it? Prefferably as soon as possible as I want to try to make Dub's at the abbey. haha.
Thank you, John.
Bob down - February 13th, 2013 at 01:40 PM
ive heard good things bout pete at custom veedub at stafford(not sure if thats too far, u could try him? ya cutting it fine for dubs tho lol
Allbones - February 13th, 2013 at 01:51 PM
| Quote: |
Originally
posted by Bob down
ive heard good things bout pete at custom veedub at stafford(not sure if thats too far, u could try him? ya cutting it fine for dubs
tho lol
|
Yeh wasn't my intension of letting it drag out this long 
BiX - February 14th, 2013 at 10:06 AM
leons motors on the south side?
Allbones - February 14th, 2013 at 10:44 AM
| Quote: |
Originally
posted by BiX
leons motors on the south side?
|
Yeh, this is who I ended up booking in with. Only problem is that he cant do it until monday so no dubs at the abbey for me.
On a lighter note it is only costing me $100, which is much better than the $270 it would have cost for a reamer and pilot.
Calcool - February 14th, 2013 at 12:29 PM
Roger at Southside VW does them!
Allbones - February 14th, 2013 at 02:43 PM
| Quote: |
Originally
posted by Calcool
Roger at Southside VW does them!
|
Just called them (in case I could get them done tomorrow), not sure who I spoke to but they said they dont do them and even if they did they wont
because they are too busy
Calcool - February 15th, 2013 at 12:10 PM
Funny When I was at Southside last time he showed me the tools to do the reaming and quoted $150 in labour to do it???
Maybe I need to get my a into g and start offering a mail order service for these???