Board Logo

Wanted , std cam spec's
RodPenrose - September 24th, 2013 at 07:57 PM

I would like to know the cam specs of a 1600 cc dual port camshaft . I need these to be accurate , so please no guesses , thanks ROD.

Old Hutcho - September 24th, 2013 at 08:55 PM

You building a stocker Rodney??:lol:

Old Hutcho

Isola - September 24th, 2013 at 09:30 PM

What specs do you need rod? I might have them in a book somewhere... will have to go hunting though

RodPenrose - September 24th, 2013 at 10:47 PM

Bob , I don't think so , but I have something special I want to try out .
Isola , I would like the running duration and spec's @ .050 if possible as well as the cam lift . I can't seem to find this info anywhere and am only guessing at this stage , ROD.

Craig Torrens - September 24th, 2013 at 11:24 PM

250, 214 @ .050, .334/.314 valve lift.

Info here.
http://www.shoptalkforums.com/viewtopic.php?f=34&t=131915 

And more here:
http://www.1800vw.bizhosting.com/caml%3Dlift_dur.htm 

Isola - September 24th, 2013 at 11:56 PM

Well fine then... I won't dig through my dusty bookshelves :p

Good work, Craig :)

RodPenrose - September 25th, 2013 at 07:17 PM

Craig , thanks for the link and the specs . It was a bit tricky for me to try and track these down . I did get your message on the other thing and was a little interested in it . I will let you know what happens , ROD.