http://www.ebay.com.au/itm/VW-BEETLE-EXHAUST-STAINLESS-STEEL-EXTRACTORS-HEADE...
I see these on eBay, price seems good. Anyone fitted these? Wondering how they sound? And perform? For my daughters car .

don't waste your money buy a vintage speed

Yes - I had one of these and they are not too bad performance wise.

Pretty sure I didnt pay that price though.

Stainless quality is pretty good.

Heat risers were not drilled out - and if you want them drilled it is a bitch because they are on the curve of the pipe and the drill will break
They are not proper heat risers like a stok exhaust either.

The slip joint is a pain, and seems harder to bind being stainless.
Problem solved with flanges, but getting the stainless flanges and then welding them is a pain if you dont have the resources handy

I would probably go the non staino for less than half the price - or spend a bit more and get the Vintage Speed.
I "think" the base version is under $500, but has flanges and proper heat risers??

Mark, I have one on my beetle, I'm at old bar if you want to come have a look / listen. Should have asked about this a couple of days earlier & you could have had a look over the weekend.

Cheers Brendan

The extractor is good but there is nothing good about the noise suppresion. As it doesn't exist. Loud as hell.

Brendan, sounds good. I've just sent you a pm.