Here I go again on another panel repro project. Front Kick Panels - Bay Kombi/Microbus

These ones are going to be tricky and I am seeking ideas from youes (thank you merrick and rosso for making this a recognised word) out there.

IDEA 1: making flat then bend to fit, ??

IDEA 2: making flat and mould before fit, but how??

IDEA 3: Making flat then give it to someone else to mould (there problem), my favourite!!

as long as you affix it well you can probably make flat and then just fit them to shape, otherwise, if u make them out of 2 thin layers of ply, you can cut them to shape, blue the 2 bits of ply together, and while they are drying affix them into the required shape. once they have dried they will retain their shape.

Make them flat, fit them, put the screws in around the heater vents and Bob's your uncle. :thumb

Let me know how you go!!!!!
how exciting :bounce:bounce:bounce
This was a problem that was to daunting for me

Hey, where on the sunshine coast are you?