If I said I can roll the lip on fender and guard edges without repainting.

Who would be interested?

I need to find out the viability and number of people who would be interested before I invest in doing this.

I am a panel beater by trade, so I understand metal.

This is only open to Melbourne Eastern suburbs.

Can be almost any vehicle whatsoever.

Roll lip without repainting if it is original paint. If there is body filler or layers of paint and putty I cannot stop that from cracking. Can do at your own house.

Expressions of interest by U2U please.

Approx cost would be between $50-80 per corner.

Peter,
Could you get a tie-in with a mag-wheel or tyre retailer so that you provide a discount 4 corners for $200 when the customer buys the new 17" mags?

This would seem to be the point at which the need for rolling would most frequently arise.

hth

That's where the $50 lower price comes in. 4 corners through a continuous deal. One off jobs with just front guards will be approx $160 the pair.

I need it doing on my 65 Orange Smoothieeee.... But i aint going to send the guards to Melbourne...

Thats a great price if you can do the job without the need for repainting.

Maybe i should take a short drive to Mel

The link below gives a description of (one approach) to guard rolling, for those interested.
http://www.autospeed.com/cms/A_0194/article.html