Ahh yes, Grease up to my elbows, I have a blown bearing to remove from my Left Front wheel.........
Any Ideas on how to get it off, Yes it is stuck Good, Tried Bashing it, Bent up two coal Chisels trying to make a dint in the bearing, That stuff is hard....

I am not even sure how to get the whole axle assembly off the car (It is a king-pin setup)..

So any Ideas....?

bearing puller

bearing puller and oxy with coal Chisel.........
:thumb

use a grinder................just don't touch the stub axle, when its thin then give it a tap with a sharp chisel, it should loosen off.