This seemed pretty general and non tech so I plopped it here.
Has anyone seen a different cluster panel fitted on a late bay? If so, how was it done?
I'd really like to replace mine one day and can't figure out how to because of the curve of the dash.
well i watch a bloke pull out the cluster and replace it with the glovbox lid and than he just filled it with whit faced gauges it had no vent slides just plane dam it looked nice
well if you have a subaru engine makes sense to have a subaru dash...this is just in pdf so far but will be replaced with stained wood....
[img]
[/img]
Greedy53, I guess you mean a real glovebox lid? Mine's plywood. What'd he do with the vent levers?
Rob, I spotted a VW A pillar, and shift knob there. Anything else still VW? Not criticizing. Just surprised. Any shots further out of the dash? How'd
you attach that?
Hi Tristan...yes one thing leads to another...it has a 1" rhs support just screws to original holes easy to remove...
[img]
[/img]
he put the vent handels under the dash very tidy
| Quote: |
I have a pic I took for another related project. Getting an incompatible fuel gauge to work, which I pretty much have. Calibration is still a little
off but pretty easily fixed.
So I might as well show you all my cluster.
