Board Logo

non vw - monitor power supply..
warb - January 1st, 2009 at 11:01 PM

anyone know where i could get a power supply for this sucker??.. its an older cheap screen, picked it up for free as it had no power supply.haha.. any leads at all?..

http://i39.tinypic.com/10psrig.jpg

matara - January 2nd, 2009 at 12:22 AM

This will give you the volts and amps you require, but not sure about the connector:-

http://www.jaycar.com/productView.asp?ID=MP3245&CATID=&keywords=19v&SPECIAL=&form=KEYWORD&ProdCodeOnly=&Keyw ord1=&Keyword2=&pageNumber=&priceMin=&priceMax=&SUBCATID=

warb - January 2nd, 2009 at 06:17 AM

cool, cheers mate!. connector looks like the one, just need to check polarity.,

sinecure - January 2nd, 2009 at 07:32 PM

If the polarity is wrong, it's low-voltage DC so just cut, swap and join the two-core output cable (properly!).

warb - January 2nd, 2009 at 10:30 PM

all good, picked my up that supply above, thanks steve.. polarity was bang on, however i had to solder on a new plug as it was different.. took me wayy back to my dick smith fun way into electronic days.. haha..