Here is the extractor system I bougt from esevwbits.

It does not fit. Its hitting the engine mount brace, before it gets half way down the thread on the manifold stud.

Shown in the pictures. What can I do?

I had the same problem,just bend them a little

Okay so that won't ruin the performance or anything?

Sounds good then.

Cheers mate

Wont effect performance,mine still sits very close but so far no problems,i guess thats why they are cheap i fitted mine to a 69 panel cheers shane.

Cheers Mate. Ill go give it a go with the gas.

Yes just give em a hit with a ball hammer and while you are under the car it looks like it wouldn't hurt to clean the oil off of the bottom of motor and those cooling fins

It is a bit dirty under there,didnt you just have this motor out joel

did u ask for a exhaust to fit a Kombi ???

Once you get it to fit they are a good system,

All good now

Haha I haven't got around to cleaning yet. I;m just test fitting everything.

Pictures pictures pictures.

Gotta love the holden carby.
Did the jets need drilling outor did you fit an adjustable one?

Love the air filter too, What carby is it?

Fuel filter may need moving.

Cant see properly but isnt the fuel filter round the wrong way??

Also put a hose clamp from the muffler bracket round the header pipe.

Have you used those heater pipe bits??
Got a pic of them??

No drilling,I wil eventually put an adjustable main jet in but for now it runs fine.

The carby is a 1/32 Stromberg off a 138, the throttle body is from a 161. Bolts onto the vw manifolds.

The fuel isn't staying there, It is only temporary lines to see how the stromberg ran. I'm getting some nice stainless lines made up.

Shit I think the fue filter is wrong. I can remember the narrow end facing the pump.

The heater pipe bits were shocking! Didnt line up at all. Ill just line them up and weld them myself.

All up though, She runs brilliantly. Kinda disappointed that the exhaust doesn't have more of a note, but I spose its a quiet pack

The heater pipes should have clamps,why do you want to weld them???

If you can weld and have the motor out SERIOSLY consider putting a flange kit on cylinder 2 & 4 exhausts

Okay cheers mate. Ill look into it. I still have a bit of welding to do in the engine bay so I have plenty of time.

One of the best things i ever did

I LOVE my heat in winter - but i was sick and tired of not being able to get a good seal
I tried high tensile bolts and all

Im talking about where the extractors slide over the heater boxes or j tubes???

Are now i see what you mean barry,looks great

Ahh yes thats the go. Looks schmick as.

Flange's make a neat job.
Stainless heater boxes look good.

Thanks mate.

They look brilliant.

How much would you pay to get heater boxes ceramic coated?

I got them done through Richard Holzl at V Force along with a heap of other things

Give him a call and talk to him

If your after a better note get a cannon, Like mine its the same header too.

Hey Bizarre - what exhaust system is that, and what's she sound like ???

Dig the old school look... wouldn't mind one on my ghia if it ain't too loud...

Quote:

Originally posted by 71-BEETLE-SEDAN If your after a better note get a cannon, Like mine its the same header too.