Board Logo

1967 Beetle For Sale
Calcool - July 26th, 2008 at 08:17 PM

Hi,

This is not my car but a friend of mine.

Solid Body and would make a good rat looker. Not Rusty. Great set of front and rear bumpers, best front towel rails I have seen for a while.

Reco 1300 Single Port 12 Volt Motor, full bottom end rebuild with New Bearings and maching all done. New flexi brake lines and wheel cylinders.

Some interesting accessories, Headlight Diffusers, Tacho, A Pillar Scuff Plates, Rear Stone Guards, Radio, Handbrake handle, Roof Rack.

Interior is orignal and the drivers seat is a bit tatty, door trims are great.

Would not take much to get rego'd, he does not have the time, just some wiring sorting out I think for the wipers and tailights.

$3500 as is with the Porsche 14 inch FUCHS with wheel adaptors or $2500 with stock rims and tyres.

Give him a call for more info, Greg 0404 09 72 18. Car is located just west of Parammatta.

Cheers,

David

Calcool - July 26th, 2008 at 08:19 PM

More Pics

Calcool - July 26th, 2008 at 08:20 PM

Even More Pics!

Pumba - July 26th, 2008 at 08:34 PM

David when you say with stock wheels are they wide 5 with usable tyres for rego and hubcaps cheers shane.

Pumba - July 27th, 2008 at 08:24 AM

Pm sent david.

klewi - July 28th, 2008 at 05:49 PM

David,

What's the low down on rust in the bug?

CHeers,

Lewi.

Calcool - July 29th, 2008 at 10:16 AM

Give Greg a call as he knows the car better than me.

There is no rust I beleive that would stop it getting thru rego, there is a funny rust hole above the drivers door handle may have been created by the finger scuff plate being installed there.

Cheers,

David

Calcool - August 19th, 2008 at 07:50 PM

Bump!