Is a t3 cv joint and boot the same part used in a t2?
pfillery - February 20th, 2014 at 09:53 PM
Some parts sites show them as the same part number. Are they directly compatible?
vw54 - February 21st, 2014 at 07:20 AM
yes interchangeable
pfillery - February 21st, 2014 at 07:26 AM
| Quote: |
Originally
posted by vw54
yes interchangeable
|
What about the driveshaft part as a whole?
Whats the best way to store some almost new ones that have been removed (still greased but contaminated with grass/dirt from removal)? They are German
made ones so I'm guessing not cheapies, would be good to keep. Should they be washed off then regreased lightly (or fully) and bagged/sealed up?
Smiley - February 24th, 2014 at 09:32 AM
T3 Drive shafts are longer.
The manual ones are about 546mm long, whereas T2 bus ones are about 476mm long.
Smiley 
pfillery - February 26th, 2014 at 08:38 AM
| Quote: |
Originally
posted by Smiley
T3 Drive shafts are longer.
The manual ones are about 546mm long, whereas T2 bus ones are about 476mm long.
Smiley
|
Thanks. Into the parts box with the cvs and boots then.