G'day Guys/Gals

I recently purchased a set of IRS bits and bobs for my Swing Axle to IRS conversion, and to make them look the part I am intending to get them powdercoated. But before I do this I need to remove (I have no idea what it is called) the rubber and metal sleeve that the pin goes through connecting the trailing arm to the pivot boxes.

Is there a trick to getting these out or do I just need to force them out with a press???

Any advice would be great

Cheers

Brad

Push them out. Make sure they mask up these areas as you dont want any paint inside these areas where the bushes sit.