I was looking at a Holley fuel regulator on ebay and now I need to know what psi regulation is necessary for say twin 40 webers? they (hollet regs) seem to have an operating range of 4-9 PSI is that appropriate.
Mitty

I am not 100% sure so please don't quote me...but I think Webers and Dells like fairly low pressure - in the vicinity of 3-4psi.....I think

There was a fair bit of info on the shoptalkforums.com - type4rum regarding this topic

I would say it is too high.
I was told to set my Fuel Pro at 1 1/2 (whhich DID measure 1 1/2 lbs when i stuck a meter on) by one mate and another said "too low" set it at 3 1/2.

I ahve since heard that Dells like slightly higher - i am gathering that is the 3 1/2 setting.
When i an bored i flip between these ranges and my car is fine.
I think i would pass on the Holley

:puke

I find 3 1/3 pounds works perfectly. It's one of those cheapish dial-type regulators. The first one I had leaked after only 3 weeks (leaking fuel is BAD).

Find the right Holley reg and it will probably be more leak proof. However, you have to set the holley regs up using a fuel pressure gauge. At least then you know it's accurate.

Depending on your level of performance you might want to consider a bigger fuel line and tank fitting.

CYA, CT:sandrine

Thanks for the replies. the thing is the cheaper regs are restrictors not regulators the holley ones are. Pressure and flow are not the same you can have huge flow at the same pressure as a pissy flow . this is where the holleys are superior. Also i dont want something that leaks. The fuel lines on later type 3 s from the tanks to the firewall is larger that most they are reduced down at the fire wall so if you remove the last section of line then they are ok for most apps.
Mitty

[Edited on 14-11-2002 by waltermitty]