Hiya dudes,need opinions what do you think of this design,i like it, ive always been looking for a system that uses both cutouts in a working twin exhaust system.Should be easy to make too,buy a set of headers and let the gorilla down the muffler shop do a few simple bends,only hard part i see is the 1 into 2 at the collector.CSP have a nice system too the best but out of my league unfortunately. http://photo.starblvd.net/Silver77/6-3-3-1071870688?m=0&pg=5&ro=2&...

Good idea and it will proberly be a lot quiter as well. Ive seen it done before They should have 2 into 1 pipes available.

just curious, how much would getting that done cost? i really need to quieten my bug.


is quieten even a word?

I had extractors and a 11inch hot dog(1.5inch)...very loud and fast,alot of red faced Z3 owners at "sanctuary cove"haha.but now I just run a standard box with straight tips out the cut outs...sounds good and looks original

oops....just for the record I'm not from sanctuary cove,:pukebunch of plastic f#@kers

hahahaha

plastic rice?