I am splitting a motor heads and everything is off , how do I get the barrels Of without damaging them?
I am assuming that this is the thing to do next before splitting the box?
Mitchell Thanks again gurus

A motor stand is handy here so as you can get a good swing in both directions.

With the motor sitting flat and a wooden/urethene/rubber mallet you tap perpedicularly (is that a word??) and slowly loosen the pot.

If you what too hard or at an angle you could/will brake a few fins on the barrels.

Take it slow and if it wont come - do another one and come back.

Is the flywheel off yet,jus checkin and if your gunna reuse your lifters yule hafta hold onto them before you split the case.Have fun anyway Michell