hi i just would like to know although i think im right..
the stainless steel that you can get to put in the engine bay.
do you just wake it straight on top of the insulation that is already there im sure you dont have to take that off because ill be left with too much noise..
just want to check..

I ripped mine out and it is loud but was told that if I didn't its to close to the motor???

hey guys how do you hold that shinny stuff in there screws bolts :thumb

took out my insulation.
pop rivoted the firewall to the body and pop rivoted the sides to the firewall so the pop rivots don't show through the inner guards.

I ripped mine out it still had the old tarboard behind it,theres enough room there just have a look.