Hi all i am putting a type 4 upright in my baja and i would like to know were to get the lower pully from, also a ball park price tim gold coast

Mike Sharp from Sharpbuilt out at Toowoomba.

I would say Mike Sharp from Sharpbuilt will sell the pulley alone - not sure about the cost though. Drop him an email to find out

web site http://www.sharpbuilt.com.au 

(beat me to it!!)

[Edited on 5-8-2004 by Dasdubber]

Yeah i tryed him this afternoon but he didnt pick up but will try again tommorow cheers

Yeah phone contact reliability is not a strong point - took me a while to get a hold of him a few times. Keep trying and you'll eventually get through!:alien

nether is his parts sending cause im still waiting for a bush for the flywheel from two years ago. but i dont have a problem with his work it top of the line.

Don't piss around using a bush-get a needle roller bearing for a Type 1 flywheel nut and use that.Get the flyweel machined for an interference fit.

had one in there but the problem is the main shaft in the gearbox is longer in a kombi than a beetle so this special bush is needed to stop u stuffing the box. and he doesnt sell it in the kit nor is it mentioned when you by said kit. but this is just a personal grudge not for the forum.