Board Logo

T3 gennie pulley to T1?
oval TOFU - October 29th, 2004 at 12:00 AM

Is it compatible onto a T1 generator? if so, how do I get the $%^! woodruff thingy loose?

*did* - October 29th, 2004 at 11:41 AM

woodruff? i dunno.
does it hold the inner half of the pulley on?

oval TOFU - October 29th, 2004 at 06:27 PM

yeh, its a semi circular thing that retains the pulley onto the generator axel..

1303Steve - October 29th, 2004 at 10:22 PM

Hi

The pulleys are different. Tap the key with punch & hammer at one end and it will pop up.

Steve

oval TOFU - November 1st, 2004 at 11:14 PM

So can I use the T3 on a T1 then? or won't it fit on the gennie axel? Just asking here before i take apart the pulley coz it's a mate's pulley! not mine!

[Edited on 3-11-2004 by oval TOFU]

oval TOFU - November 3rd, 2004 at 01:48 PM

?

Craig Torrens - November 3rd, 2004 at 01:55 PM

Check if the offset is the same, the shaft size and nut etc will be the same.

oval TOFU - November 6th, 2004 at 11:59 PM

cool.. the only thing is, there's no cut outs to jam a screw driver in so you can unbolt the nut!