Board Logo

externel oil cooler's
kombi_kid - November 1st, 2004 at 03:16 PM

hey guys
what sort of externel oil cooler best suits a kombi and where should it be located?????? pics would be great if possible!
cheers
rhys


kombi_kid - November 2nd, 2004 at 11:40 AM

so no one has one in there kombi's??? common guys!
cheers
rhys


kombikim - November 2nd, 2004 at 12:00 PM

I have & I found the thread in tech but the pohotos are gone

mine sits flat about 1/way up vehicle between heater tube & closest longitudinal "chassis" , it works so well that it has been wrapped in light sheet aluminium since about April to keep oil warm enough, unwrapping again soon though


BiX - November 2nd, 2004 at 12:10 PM

I found i had to put a alum plate over min in winter and wrap the lines in themo wrap to keep them warm, as it ran really cold.


nbturbo - November 2nd, 2004 at 01:08 PM

sounds like you need one of these to keep your oil temp up


nbturbo - November 2nd, 2004 at 01:09 PM

or one of these if you have a Type4-a bit neater fitting


kombikim - November 2nd, 2004 at 01:16 PM

yep, I need a thermostat of some sort, have a remote filter, that is underneath battery floor


kombi_kid - November 2nd, 2004 at 01:37 PM

so what sort of oil cooler did u use???? did u use a separate oil filter???? you obviously didnt need to run a thermo fan?
cheers
rhys


Chewy - November 2nd, 2004 at 02:24 PM

For the oil cooler I'd say get something like an auto transmission cooler from any late model car from the wreckers. Would be a hell of a lot cheaper than buying new.


Craig Torrens - November 2nd, 2004 at 02:39 PM

Quote:
Originally posted by kombikim
yep, I need a thermostat of some sort, have a remote filter, that is underneath battery floor


That's what the pressure relief valve is for in the oil circuit.


kombi_kid - November 2nd, 2004 at 03:10 PM

yer thatnks chewy everyone using 1/2" lines???
cheers
rhys


kombikim - November 2nd, 2004 at 03:16 PM

yep


kombi_kid - November 2nd, 2004 at 03:43 PM

kim can u draw a diagram of how it all plumbs up etc just so i get an idea of where it comes in and where it leaves for the cooler?
cheers
rhys