Have a question on t3 extractors. Once bolted to the motor and in the car how far does the extractor flange sit from the rear apron ( valance).
I'm getting a custom muffler made up and need a rough measurement.
cheers Dan
Just gone and measured my 62 the flange is 30 mm but the silencer pipe comes out lower than the apron.
What car have you measured it from and roughly how much lower is it. Could you run a Stinger or would you need a cut out in the apron?
Cheers , thanks for being bothered!
Dan
on the 69square, my stinger fits fine.. clears the apron...
as long as you get a type3 stinger..
T3 stinger , Frenzix are you pulling my pud? Never heard or seen one.
Dan
teehee
any 3 bolt should do
LOL , bloody knew it!
Dan
If your planning on using a stinger im assuming this is a hot motor. Where are you getting big headers from. I had to build my own 1 7/8 system when I put the 2.3 with IDA's in the squareback.
| Quote: |