I have finished supercharging my 1600 kombi using a toyota blower it was of a injected motor but I am running a delorto 40 on home made manafolds but using factory crossover been to victoria and have had no major problems if you go http://au.photos.yahoo.com/breedy51 
you can see ahappy snap of it in car i think it under blower
greedy51:repuke

[Edited on 28-1-2003 by amazer]

So ....

How does it go, Greedy

Looks good.
Looks like a blower from a 4agze 1600. Is this correct?

it goes really well and there is vast room for improvement i would say that it gives a bost of about 50-60% on power and i managed to fit mine for the grand sum of $550.00 by doing all the work at home in my little boys shed
and it is a toyota 2lit blower
steve:beer

Very Nice.

What about engine temp you noticed and raise in the the temp the engine runs. Im thinking of building up a supercharged motor. Either Type1 or 4.

Cheers

Joel

Steve, my favourite part was your home-made adjustable blow-off valve!:thumb I'm keen to find out what happens when you change the pulley size.

Whats the chance of some drawings / photos of the mounting hardware etc ?

Looks awesome. Must be so much fun.

Any chance that could fit under a beetle decklid?

Dont suppose you wrote down the fuel consumption figures on the trip MATE..?
I Know that you returned better fuel consumption than the webbered 1776cc
but how did it go when towing the Two Tonne Trailer.?