Advice....I've just found out that my 1600 bug engine is only running basically on two cylinders......there is no compression on cylinders 3 and 4. This apparently therefore means a valve job.

For the work, start to finish, from when I drive the car in, until I drive it out (engine removal, work on it, engine install, etc), I received a quote of about $500, as long as there are no unforseen problems, which they don't believe will happen. I believe there is a few days in there, start to finish.

Is this an OK price?

If they stick to it! about 4years back, $300 to remove and install the donk was about the going rate!, so to strip tinware, carbs exhaust, pull heads, remove valves, replace fucked ones, etc etc etc etc (never that simple!) i rekon $500 is an underestimate...just my thoughts! good luck

yeah - not out of the park.

more than a days work there.
Pull motor
Carb off
manifold off
tin off
exhaust off - hope no studs break
valves replaced

then reverse


Put it this way.
I wont be offering to do it for that money!

bwaahahaahahhaahaaahaah
:P:P:P
"hope no studs break" Thats some funny shit!! ...or pull...or thread...

That would be an experience - wouldnt feel quite right!

Quote:

Originally posted by VWENVY bwaahahaahahhaahaaahaah :P:P:P "hope no studs break" Thats some funny shit!! ...or pull...or thread... That would be an experience - wouldnt feel quite right!

Would be a good time to pretty up the tin ware if it's not already.

Just make sure they put all the tin back... you don't want any colling issues after that.