Board Logo

Notching tool for chris ( for notching pipes )
seagull - May 13th, 2005 at 12:28 AM

The is the notching tool I made so I can make a clean fish mouth in pipes

The shaft is a sigma strut
slide ( bearing ) from the strut

some bits laying about and machine the V block from bar stock

This uses a bimetal hole saw , can cut up to 100mm pipe .
units fits a stand up drill on slow speed with cuting oil .

[Edited on 12/5/2005 by seagull]

seagull - May 13th, 2005 at 12:29 AM

.

seagull - May 13th, 2005 at 12:32 AM

.

seagull - May 13th, 2005 at 12:33 AM

Ajustment on rear for differant angles

[Edited on 12/5/2005 by seagull]

seagull - May 13th, 2005 at 12:35 AM

.

seagull - May 13th, 2005 at 12:36 AM

.

Chewy - May 13th, 2005 at 08:03 AM

Thats sweet man
you can get cheapies on ebay for about $30.. no where near as good as that tho.

Desert Moose - May 13th, 2005 at 10:58 AM

Thanks for the pic's......;)

some nice work mate:thumb