I want to fit a close ratio shifter to the Helbus.

I have looked on the Flat 4 website and they don't list a type 2 elimimator shifter.

Comments appreciated on these or other brands. Scat, Empi?

The shifter must be suitable for a bus, and do not want a shifter with a big T handle.

I have rung some places and get varying answers, so I thought I would get some feedback from owners who have had them fitted.

Get a SCAT one from Custom Offroad....works well for me!! You could always unscrew the "T" handle and install something else?

I like the look of the Empi shifter.

http://www2.cip1.com/ProductDetails.asp?ProductCode=ACC%2DC20%2D3593 

Is the Scat one similar?

Hmm this is a Scat one?

http://www2.cip1.com/PhotoGallery.asp?ProductCode=C15%2D80503 

Not so keen on the extra handle for rev lockout.

i have the empi one its awesome really easy to fit and shortens the shift throw by alot, not to mentions tightend the gear stick feel as well (less slop)

there's always the $10 quick shift kit, that retains your original shifter. you don't need to cut the floor mat either.

Hmmm I do like the look of the empi one, and it would be good to have all new parts.

Lobus, can you get a closer shot of how much of the mat you had to cut? Or anyone?

Our mat has a couple of cracks just around the shifter anyway.

the bigger hole isnt too large i think i cut mine at 2-3cm each side

Lobus, You going to DOVW? If so I will check out your shifter there.

I have a Scat one and have found them to be the best on the market for the money. If you get a Empi one make sure you have a look at the quality of it. In particular the wire that goes to the reverse lock out from the trigger. I have had a few brake and leave people without reverse, that is one big advantage on the Scat it has a solid shaft running to the lock out plate.

Can the T be removed and a ball put on ?

go the Scat.
2nd best there is.