Board Logo

just wont run
Anthiron - March 19th, 2006 at 10:04 PM

did u replace the condensor?


always replace condensor and points at the same time

is say this is your problem


pod - March 19th, 2006 at 11:16 PM

Yep as Anthiron says,plus if the condenser was fried she wont go:no:


h - March 19th, 2006 at 11:24 PM

yep as they said above..


dubbill - March 20th, 2006 at 09:17 PM

do you know how to check to see if its getting a spark????
that is in the dizzy cap with the points closed ignition on and a non conductive (wooden,rubber etc) instrument to push open the points n see or even hear the spark
engines run on some basic ingredients ie fuel SPARK timing and compression and its in that order you should check at any break down
by the sound of it only one of these has changed spark see if the condenser rectifies the problem