hey all,
the float in my right carb decided life was a bitch and imploded on me today so i had to put my single carb back on which really doesnt agree with my engine and extractors
yes preheaters are flowing fine but after a 20min burn out the road u can see what my manifold temp was at
jettting is fine, solenoid is working and all setup ok just ices up abit which causes it to stumble down low

any tricks to help over come this, ive sealed up the tinware for my old aircleaner preheat hose so i cant replace that
i'll be getting a new float in the next few days so im not realy worried about spending to much $$ on the 34pict3 but any little tips to help would be appreciated

thanks
Joel

oops sorry should be in tech talk

Joel

use some more of that cheap non genuine fuel hose... it'll warm up sooner or later.