Board Logo

Flywheels
DubCrazy - February 3rd, 2007 at 10:01 PM

Was going through some of the engines i have sitting in my shed and i noticed that one of them has a smaller flywheel, they are all 200 clutch plates but one has a smaller diametre(less teeth). I know this engine came out of a later bug than the rest earlier. Anyone know why? is it 6volt/12volt?

cheers

seff......................

xornge666x - February 4th, 2007 at 09:31 AM

The one with smaller pitch teeth is 12V. (more teeth and larger diameter)
The one with larger pitch teeth is 6V. (less teeth and smaller diameter)

Grey 57 - February 4th, 2007 at 05:22 PM

The 200mm clutch one that's smaller with less teeth will be early Type 3 (6volt).

xornge666x - February 4th, 2007 at 07:35 PM

Quote:
Originally posted by Grey 57
The 200mm clutch one that's smaller with less teeth will be early Type 3 (6volt).


most likely with a stepped crank.... just check the crank and your end float..

DubCrazy - February 4th, 2007 at 08:46 PM

thanks for that... thought it was the 6 volt/12 volt sizing....

steff..............