can someone please tell me the correct position of the rings on the pistons?that is the end gap positions.thanks in advance.
Homer

http://forums.aussieveedubbers.com/viewtopic.php?tid=38560&page=6 

don't forget the arrow on the top of the piston must point to the flywheel, and realize this means the rings will be positioned differently depending which side of the motor you intend on using a particular piston

they should be equally spaced or 120 degs apart

if the oil ring is a 3 piece type then put the 2 out rings 180 degs apart

as long as there seperated at the start then they will stay that way during the life of the engine