Board Logo

carbi tune prob;any suggestion?
lohoon - December 2nd, 2007 at 08:04 PM

Hey all,
I am running twin kads on a 1600.
its favouring clys 1&2 .U can hardly notice when i pull 3or4 plug leads off.
the inlet manifold for 3&4 is very cold.I'm guessing the float level may need adjusting.Does anyone know where i can get a diagram to show how to set the float level?
cheers
scott

greedy53 - December 2nd, 2007 at 08:50 PM

give vintage vw at campsi nsw a call if they cant help no one can and they will tell over the phone

matberry - December 2nd, 2007 at 09:46 PM

Check carb balance. Increase idle speed on 3/4, and decrease on 1/2, untill same idle speed drop on all cylinders, then reset linkage balance very carefully so both carbs start opening off idle at EXACTLY the same time.

Bizarre - December 2nd, 2007 at 09:52 PM

lots of Kad info here

http://www.lowbugget.com/help_section.html 

13bwagon - December 3rd, 2007 at 07:23 PM

make sure the valves are not over tight

lohoon - December 3rd, 2007 at 10:18 PM

Thanks for your suggestions.Will have a fiddle and see what we can sort out.