Hi

Found this Radius Master multi station belt grinder on the net. http://www.radiusmaster.com.au/ 

Steve

It looks good.

I've got an Abbott & Ashby 8" bench grinder with a Multitool belt and disk attachment. Not quite as good as that, but at just under $400, I bet its a lot cheaper.

Unfortunately, its now located in the mud, 34' below my boat courtesy of some bastard who doesn't know what a "No Wash" zone means. There's a pair of $500 glasses down there too.

Hi

I rang the guy, it 1899 + GST, they are bringing out a basic one soon for about a 1000. Bad luck about your unit, he must thought you grinder needed a wash, excuse my poor sense of humour.

Steve

Yeah, I got a wash as well. The boat is quite stable, but I took a knock on the shoulder as I was carrying the (rather heavy) grinder down the side deck. Next thing I knew I was heading for the piss. I threw the grinder as far as I could so I didn't knock myself out on it as I hit the water. I tried a grappling hook - but couldn't locate it.

Mate - at over $2k, that's not exactly cheap is it? I think my engineer mate has something similar. I'll check it out next time I'm over there, which I need to do soon. I need to get my Kafer bars finished.

looks like stock linisher belt set up