Board Logo

Cable
donn - May 9th, 2008 at 07:01 AM

need to know the diameter of the fitting on the g/box end of the clutch cable, anybody out there can advise?
thanks
don

68AutoBug - May 9th, 2008 at 02:31 PM

Do You mean the diameter of the hole IN the clutch arm ??

Lee

donn - May 9th, 2008 at 04:16 PM

No, the diameter of the fitting on the end of the cable, I need to know so that I can make up a cable (needs to be shorter than standard for a short wheel base pan) that I can push through the tube in the tunnel

Old Dubber - May 9th, 2008 at 07:40 PM

6mm

donn - May 9th, 2008 at 10:33 PM

Ta

Brian - May 10th, 2008 at 05:35 PM

7mm thread :yes:

donn - May 11th, 2008 at 09:12 AM

????????????? 6mm with a 7mm thread? got me there but at least I have a starting point, thanks for the help.

matberry - May 11th, 2008 at 09:20 AM

The thread is M7