Does any one know if i can buy or who i can get t mak up some cut down grease caps from?

I need to belt mine with a hammer because the Porsche cap is concave and it will pop otherwise.

The driver side just looks ugly but the side with the speedo cable hole gets all out of shape.

So - has anyone bothered with this?

Buy a pair of new ones and I cut them down for you..

Barry your better off just panel beating the existing ones down abit

theres no more than 5mm between the inside of the cap and the spindle

i had the same drama and had flatten them out with a hammer

you cant go to far as they spin with the disc where as the spindle is stationary so there cant be contact between the 2