Lower Front Beam
Newt - August 10th, 2009 at 11:21 PM
Hi Guys,
I noticed in Wrecker Racer in this months VWMA that they only fitted a adjuster to the top beam.
Any thoughts on this?
Cheers
Newt
Dirtbag - August 13th, 2009 at 09:51 PM
Doing so will put too much pressure on the torsion leaves in the beam without the adjuster. Spend the extra $50 and do both beams.
chunks54 - August 13th, 2009 at 11:54 PM
I have heard of fitting two adjusters and then using the two to fine tune both the height AND the spring rate by adjusting them against each
other....
But dirtbag has it - use two.
Newt - August 14th, 2009 at 12:35 AM
Cheers Guys.
Newt
68AutoBug - August 14th, 2009 at 01:02 AM
| Quote: |
Originally
posted by Newt
Hi Guys,
I noticed in Wrecker Racer in this months VWMA that they only fitted a adjuster to the top beam.
Any thoughts on this?
Cheers
Newt
|
I have heard over the years of people only doing one adjuster...
I can't see how one would really work...
its just loading up against the other one...
I think I only adjusted one of mine to start with..
and teh front end was like it was SOLID.... terrible..
You do need the two....
LEE