Hi all,

I need to find out the original size of these holes that the fresh air heater tubes pass through. I need to cut my own and want to check what size hole saw I need to use/buy.



I need to cut them by morning so I can drop my tinware off to get powder coated.

Thanks, Kevin

60 mm

That was quick, thank you. Need to go buy a 60mm hole saw now, one of the sizes I don't have.

Cheers, Kev.

First time I've heard of anyone cutting those holes in... normally it's people wanting to block them off !!!

Hey Kev, just duck down to the 'holesale shop and buy a couple of 60mm holes.

You guys can laugh at my expense and expense it was. Worked out $22 a hole to drill

Anyway, it's done now and can drop them off at the powder coaters

I was really surprised at the mods required to the tinware to make them fit. Then again my engine is stroked and running 48 webbers.

Shit, the way I am going I might even have the engine in soon.

Kev

hurry up will yar

Quote:

Originally posted by Camo Hi all, I need to find out the original size of these holes that the fresh air heater tubes pass through. I need to cut my own and want to check what size hole saw I need to use/buy. I need to cut them by morning so I can drop my tinware off to get powder coated. Thanks, Kevin