Hi,
Someone on here a while ago had there dropped spindles engineered and went through the rigours of pressure breaking a set to fit out how strong they were. They were CB spindles. Can anyone remember this and who it might have been.
I would like to contact this person and see if I can come to and arrangement with engineering papers.
Any help with who this was would be great.
Barls springs to mind but not sure.
Heath
T54

Please leave this in general chit chat.

99% it was Golde60

here you go
http://forums.aussieveedubbers.com/viewtopic.php?tid=27343&page=8#pid382564 

Thanks Bizarre, i PM him and see if I hit gold.
Heath

Turbo

any news from Golde? I am curious as well.

Ta