wiring loom
clyve - January 21st, 2012 at 03:43 PM
does anybody know where i can get a complete loom for a 72 bug and also where does the wire off the -ve terminal on the coil go to please
(down the harness under the seat?)
cheers
68AutoBug - January 22nd, 2012 at 12:08 AM
| Quote: |
Originally
posted by clyve
does anybody know where i can get a complete loom for a 72 bug and also where does the wire off the -ve terminal on the coil go to please (down the
harness under the seat?)
cheers
|
--- ve
the Negative Terminal is connected to the distributor
the Positive to the ignition [power]
do You have a pic of the engine?
a Complete wiring loom [new] is Very expensive.... $$$$
sounds like someone has been fiddling/modifying the wiring??
cheers
LEE
AA003 - January 22nd, 2012 at 06:28 AM
| Quote: |
Originally
posted by clyvewhere does the wire off the -ve terminal on the coil go to please
|
The -v wire (1) goes to the points. If there is a second wire, it goes to the VW Diagnosis socket or it is non standard which could be a tacho or
engine immobilser/alarm.
clyve - January 22nd, 2012 at 03:13 PM
thanks for the help. I have two leads on the coil on the positive side? plus the one to the fuel solinoid and choke.
there should be one according to haynes manual.
The plug on the back fire wall i take is the test point. do i need this or can I rewire with out it, there seems to be shit loads of wires so I am
going to start again.
any tips
cheers
AA003 - January 22nd, 2012 at 03:34 PM
You can delete the socket and its associated cables.