A sorry site at the moment......................but soon to be a offroad BEAST !!!!

Working on the side intrusion and integral rollcage/windcreen...........

Starting to work on the front beam, bracing the shock towers as well as welding the tower joins............ adjusters and rebound/bump stops still to be done!!

good to see some serious thoughts to safety going into this project, shows what a high level of thought and planning goes into your projects

If you want somewhere to store that white beetle in the background of the first pic .....

my garage is free!

you should see what's in my other garage

Wat is it craigie come on tell us come on???

Hang on hang on, let me guess!!! issss it mmmmmmmmmmmmmm ummmm a circuit racing car by any chance...????

Craig,

I like your roll bar work, I can't wait untill it's all finished.

:thumb

I can't do much until I get my pan from WHM !

The bar work should help stiffen the buggy a lot. The cage will bolt to the pan as per the picture, as well as down to the gearbox forks and the rear torsion housing.
I will get some more pics soon !

I understand why you want to stiffen your buggy, the twisting that I get is unbelievable. My pan has 25 X 50mm tube up the sides and I don't think that that is enough. I'm planning to weld a 50 X 50mm section on top to help stiffen it which will also raise my body by two inches. I'm not sure if this is the look that I want but with what I do with my buggy I need to stop some of the twisting.