I spent the last few days removing dents and trying to remove the tray. Here's a few pics.

Looking great!

Did you MIG the pull-pins on to the rear corner dents to pull them out?

I bit the bullet and bought the proper tool. After using it it's worth the money. check out how many pins I needed for the nose.

great work! what type and brand is the spot welder and how does the puller attatch? Is the puller a manual or hydraulic unit.

Can you put some pics of the spot welder and what are they worth?

Sweet as, i tell u what thou it will all be worth it in the end. Great work on the nose!

Here's a pic of the spot welder. It's made by stinger. This is the best panel beating tool I own. The down side is the price, they cost upwards of $1100. The puller attaches by tightening the jaws of the slide hammer onto the pin. The weight is missing off the slide hammer because I used it on the tool I made to un-pick the sides of the tray. Its a pretty simple tool, it was 5:30 am when I made it.

Sorry That was the tool I made. Here is the spot welder.

great work man, looks like a long road ahead with the tray. almost looks like ur performing acupuncture on ur bus...
see u in the morning to move the rat buses...
sam