took the motor out yesterday getting ready for
sandblasting
the flywheel still free running after 20yrs idle
[Edited on 6-4-2005 by winerot]
ooh more piccys, keep them flowing pleeeze
have my own pump to fill her up
:P:P:P:P:P:P:P:P:P:P:P:P:P:P:P
theirs a lot of cutting to be done & replacement panels & roof
i want that pump, your in lismore hhey?
found this when i was digging out the bog to see how big the
hole was too my surprise the semaphores were bogged up
nice find something positive
a bloke up the road from me used to have his own panel shop
with about 15 working for him gave it away too much stress now
he works from home with his son both learning there trade on vw's
has given me an estimate of $10th to have it fully blasted, rewelded
& painted i told him to be careful dont underestimate the cost of bringing
it back to life but he believes that will be a close estimate.
mind you he's set up is second to none & is constantly working on vw's
have seen he's work first hand can not fault it.
will take pic's as the project carries on plus if possible some of the vw's
he has now including a nice beetle cabriolet he is restoring
mullaway 5 k's nth of woolgoolga
good work mate, keep slugging away
keep the pics coming
u2u me details of this guy, might have to pay him a visit, could be good for my bus...mullaway is near arrawarra?
mullaway arrawarra is the same turn off
byronbus i will get phone number for you.
he takes hes work seriously right into vw's, when i first met him &
checked out hes setup its excellent. steve has all the colour codes
for vw's right there in his office. if you have been to arrawarra & the
local shop thats mine. classic part of the coast from coffs to well where
you live lots of unpopulated beaches.
probably see you ppl at nimbin where coming to byron for the nimbin convoy.