Board Logo

its been a while but finally started
lulu94 - August 8th, 2007 at 08:34 PM

its been a while but we have finally started work on the beetle so i thought i would post up some pics and show ya what has been happening.
its a 67 1500

anyway here are the pics for ya


as she started out as


lulu94 - August 8th, 2007 at 08:36 PM

some more


lulu94 - August 8th, 2007 at 08:37 PM

pulling off the guards


lulu94 - August 8th, 2007 at 08:40 PM

oh no dredded cancer, acctually the hole was caused when trying to undo the guard bolt and the body just pulled out


lulu94 - August 8th, 2007 at 08:43 PM

bit more demolition oops i mean progress


lulu94 - August 8th, 2007 at 08:47 PM

a dummy up to make sure the doors and guards will fit
we plan to look all over for rust and fix what we can before sending to the panel beaters and getting repainted.
unsure whether we have to pull it off the pan, want to avoid it if possible, we would like to try find 2 donor pillars if possible, pretty hard up here in alice and to find one not rusted out but hopeful.


one4 - August 8th, 2007 at 08:58 PM

Hey Danielle,

Good to see your work on the beetle.
What's on the plans for her?

Richard


lulu94 - August 8th, 2007 at 09:05 PM

oops forgot to show the bend/crack in the rear

hey Richard, plans are to get her stripped back as she has a few layers of paint and some of it badly cracking over lots of bog, a real nice paint job, change of colour, not telling yet.
wide guards and one piece windows, not to much really but enough to make it look like a sweet lil ride, and hopefully with the climate here once we get rid of the rust hopefully it wont come back


lulu94 - August 8th, 2007 at 09:07 PM

so how is your beetle going btw, get the bonnett fixed/replaced, havent see ya around for a while either


ang3lsholocaust - August 9th, 2007 at 11:37 AM

Try Classic Veedub in sydney or Mick Motors in Brisbane for new replacement pilla sections. They really aren't real exspensive at all

jace


lulu94 - August 10th, 2007 at 08:16 AM

cheers for the heads up Jace will look them up and give them a buzz, that helps heaps

Danielle


Rota_Motor - August 11th, 2007 at 11:19 AM

one thign Danielle didnt really mention, the crack and bend in the left rear inner guar, that isnt supposed to be bent is it?? probably from having the rearend pushed forward a bit??

there is also a little distortion in the front of the body where the spare wheel should slide in, we have a 165x15 tyre on a standard rim, and it wont even go in the stock spare wheel hole.

Danielle also didnt mention, I think there is a tonne of bog hiding all sorts of body issues in this car. once its all repaired properly, it shuld weigh a little less and go a little better.